BelFox 47-21-0 Instructions D'installation page 57

If safety switch 2 is set to the ON = SE position, an electrical safety contact strip
can be connected to the LS / SE 2 input, which must be terminated with an 8.2
k: resistor. In the case of an electrical contact strip, the outer contact of the
rubber profile must be clamped to terminal 15 (ground); in the case of contact
strips, this is the white connecting wire. Motor run is not possible when LS / SE
2 input is actuated. The LS / SE 2 input has the effect of short enable in motor
run OPEN and CLOSE. When the automatic closing function is activated, the
closing time is reset by actuating the LS / SE 2 input and remains reset until a
new pulse is given. The LS / SE 2 input is self-monitoring. The input is tested
during each self-test. If an error is detected, no motor run is possible.
2 2 2 2 . . W W i i c c k k e e t t d d o o o o r r s s a a f f e e t t y y d d e e v v i i c c e e
If there is an additional wicket door on the gate, the drive must be prevented
from starting when the door is open. For this purpose, a switch with a normally
closed contact can be connected to terminals 11 + 12 (stop).
2 2 3 3 . . D D e e l l e e t t i i n n g g a a l l l l r r a a d d i i o o c c o o m m m m a a n n d d s s
No other gate function may be triggered during the entire extinguishing pro-
cess.
Press the radio learn button for at least 6 seconds, then all codes are deleted.
During this process, the radio LED flashes for the first three seconds as during
code learning, then this LED flashes very quickly, after which this LED goes out
and all codes are deleted.
2 2 4 4 . . D D e e l l e e t t i i n n g g t t h h e e r r u u n n n n i i n n g g p p a a t t h h a a n n d d t t h h e e t t a a u u g g h h t t - - i i n n f f o o r r c c e e
To delete the taught-in travel path and force, e.g. when changing the drive to
another gate, proceed as follows: Set all DIP switches to "OFF". Then press the
following keys one after the other:
1x Press RADIO button
2x Press IMPULSE button
1x Press RADIO button
NOTE
Radio – LED flashes
Radio – LED flashes 3x
Radio – LED stays off
25