BelFox 47-21-0 Instructions D'installation page 48

x Make sure that neither persons nor objects are in the path of the door.
x If possible, the door should only be operated when there is visual con-
tact with the movement range of the door.
x Monitor the door movement until the door has reached its end position.
x During opening and closing of the gate, the working area of the gate sys-
tem must not be entered or passed through!
x Do not stand still in the opened door system!
x
If possible, install an emergency stop command device in order to be
able to trigger an immediate stop in an emergency.
During gate run, limbs and fingers may be pinched, crushed or severed be-
tween the gear wheel and the gear rack!
SAFETY INSTRUCTION FOR DANGER AVOIDANCE
x Do not touch the gear wheel or gear rack while the gate is moving.
x Make sure that children do not touch the gear wheel or gear rack while
the gate is moving.
x If possible, the gate should only be operated when there is visual con-
tact with the movement range of the gate.
x
If possible, install an emergency stop command device so that an imme-
diate stop can be activated in an emergency.
During all learning trips, the gate must not be stopped by light barriers, safety
contact strips or anything else or prevented from running
normally.
After plugging the Schuko plug into the 230 V socket, the control unit carries
out a self-diagnosis, indicated by red flashing, approx. 3 seconds after this the
green mains LED lights up.
The drive and the controls learn its force requirement and its soft run them-
selves. For this purpose, learning runs must be performed. Move the gate a
total of four times from limit switch to limit switch by pressing the pulse button
on the motor control unit. The gate must not be stopped by radio or by the
pushbutton during these learning travels!
WARNING
Risk of injury on the gear rack
CAUTION!
16