Proper Use; Non-Approved Use - BelFox 47-21-i Mode D'emploi

2.3. Proper use

This motor control is constructed to be used with a BELFOX gate drive.
Reliable operation is only possible if the unit is carefully installed in ac-
cordance with these instructions.
Observe the manufacturer's instructions regarding the gate system, con-
sisting of gate and gate operator. You can avoid possible hazards within
the meaning of EN 13241-1 if the installation complies with the specifica-
tions in these instructions.
Gates which are operated with a gate drive must comply with the applica-
ble standards.
The gate must run evenly so that the safety cut-out can react optimally.
The gate must have mechanical end stops in the open and closed position,
otherwise it can be pushed out of the guide when the gate is in the
"emergency release" state.
Gate systems which are located in public areas and only have one safety
device, e.g. force limitation, may only be operated under supervision.

2.4. Non-approved use

The product may only be used for the purpose intended by the manufac-
turer. Any other use is considered improper and therefore dangerous. We
cannot give any guarantee or warranty for damage caused by other uses
or incorrect installation and are not liable for this either.
Changes, additions and/or conversions to the drive or the control system
which are not in accordance with the intended purpose may lead to un-
foreseeable dangers.
7