Programming; Delete - BelFox 47-21-i Mode D'emploi

1 1 2 2 . . T T e e a a c c h h i i n n g g - - i i n n o o f f t t h h e e r r a a d d i i o o c c o o d d e e s s
NOTE: If one of the two systems (12-bit or 18-bit) has been programmed in a
system, only radio transmitters with the same bit system can be taught in. To
change the system, you must delete all the taught-in radio transmitters.

12.1. Programming

Press the "Escape/Menu" key repeatedly until the display shows "Radio lev-
el:". Confirm with the "
Now the display shows "Learn radio?", confirm this with the
" / Return" key.
Now use the "↑ +" and "↓ -" buttons to select the desired radio function (see
list below) and confirm with "
Radio functions: F1: Impulse (Open-Stop-Close-Stop-...)
F2: Open with stop (Open-Stop-...)
F3: Close with Stop (Close-Stop-...)
F4: Stop
F5: Partial opening (Personnel gateway, see menu
item 9.8-p.23)
F6: Open without stop (Open-Open-...)
F7: Close without stop (Close-Close-...)
F8: Light (switches on the light relay)
Now press the desired remote control button permanently until the
second line of the display reads "Detected: °SPXX°FY" lights up. The hand-held
transmitter key is now taught-in.
If only the display "Detected:" appears, the remote control key has not been
programmed.

12.2. Delete

You can delete all or only individual remote controls.
Press the "Escape/Menu" key repeatedly until the display shows "Radio level".
Confirm with the "
Now use the "↑ +" and "↓ -" keys to select the desired "Delete radio?" func-
tion and confirm with "
/ Return" key.
/ Return".
/ Return" button.
/ Return".
39