Unpacking The Ups - Tripp-Lite SmartOnline S3M Serie Manuel Du Propriétaire

3. Installation and Wiring

3.4 Unpacking the UPS

Notes:
• Do not tilt or lean the UPS when removing it from the packaging.
• Ensure the UPS was not damaged during transport (refer to section 3.2.1 External Inspection). If any damage is observed, do not power
on the unit. Immediately contact the dealer from whom the UPS was purchased.
To unpack the UPS:
1. Use a pallet truck to transport the UPS to the installation position.
2. Check the UPS packing.
3. Hold the sliding plate steady. Cut and remove the outer wrapping.
Models S3M25K, S3M30K
4. Remove the plastic bag and take out the box of fittings.
5. Check that the UPS is intact. Visually inspect the UPS for any apparent shipping damage. If the unit is damaged, notify the
carrier immediately. Check the accessories against the packing list. In case of missing parts, contact your dealer.
6. Unfasten the screws and remove the wooden bar or sheet metal affixed to the cabinet.
Models S3M25K, S3M30K
Models S3M50K, S3M60K
Models S3M50K, S3M60K
13
Models S3M80K, S3M100K
Models S3M80K, S3M100K