V-200716
Operating manual
Dismantling the head bearing
► Loosen the bolt on the knife head.
► Remove the head bearing from the
knife head. You can spread the
knife head somewhat by inserting
a small screwdriver into the slot of
the knife head.
Installing the head bearing
► Insert the head bearing in the new
knife head and align it roughly.
You can spread the knife head
somewhat by inserting a small
screwdriver into the slot of the
knife head.
► Tighten the bolt hand-tight.
Mounting the knife head
► Place the knife head on the
sections.
► Tighten the bolts to the specified
tightening torque.
71