Replacing Sections - EWM KM 120-S Notice D'utilisation

Operating manual

Replacing sections

In case of breakage, single sections of the installed knives can be replaced.
60
Removing a section
► Unscrew the nut of the double
guard on the damaged section and
remove the bolts.
► Push the double guard to the side
in order to access the knife bolts.
► Loosen the nuts on the damaged
section and tap the serrated stud
bolts to remove them.
► Remove the section from the knife.
Mounting a section
► Position the new section on the
knife.
► Insert the serrated stud bolts from
above.
Always use new serrated stud
bolts!
► Tighten the nuts to the specified
tightening torque.
A018H