Replace The Guard - EWM KM 120-S Notice D'utilisation

Replace the guard

A guard must be replaced if it is bent or damaged, or if the cutting gap has reached the wear mark
of 5.4 mm.
V-200716
Operating manual
► Check the cutting gap for
parallelism.
► Observe the section while it runs
very slowly.
If the knife scrapes or does not run
straight in the cutting gap, the
cause must be determined and
eliminated.
Remove the double guard
► Unscrew the nuts on the damaged
double guard and remove the
bolts.
► Push the double guard to the side
in order to access the knife bolts.
► Loosen the nuts on the
corresponding section and tap the
serrated stud bolts to remove
them.
► Remove the section from the knife.
65