Control/Refreshing Of Oil Level And Pump Oil; Control/Refreshing The Reduction Oil - Oil Level; Maintenance Engine; Cleaning Of The Water Filters - Dibo PTL Mode D'emploi

E N
S E R V I C E

Control/refreshing of oil level and pump oil

3
Check for each use of the machine the oil with the oil level glass or with the oil
level bar. oil must stand right with the sign of the oil level glass, if the this case
is not, oil tops up until the sign. If oil looks forward to there milky, consult directly
the DiBo technicians. To refresh oil, as follows work goes:
• unbolt the drain plug below the pump.
• unbolt the tap with the oil level bar.
• Catch all oil in a barge and remove oil like further described in the guide.
• Force up the drain plug there and top up the oil in the breach to the upper
part to on the mark line.
• Force up the tap with the oil level bar there.
• Recommended oil: 1.836.042.

Control/refreshing the reduction oil - oil level

4
Check for each use the machine the oil with the oil level glass. oil must stand
right with the sign of the oil level glass, if the this case is not, oil tops up until the
sign. If oil looks forward to there milky, consult directly the DiBo technicians. To
refresh oil, as follows work goes:
• unbolt the drain plug below the reduction gearbox.
• Catch all oil in a barge and remove oil like further described in the guide.
• Force up the drain plug there and top up the oil in the breach to the upper
part to on the mark line.
• Recommended oil: 1.836.015.

Maintenance engine

5
For maintenance activities to the engine we reccomend to consult the supplied
instruction manual for use of the engine. Recommended oil: 1.836.011.
‘
While the engine is still warm, change the engine oil !
Attention: if the engine is tipped during maintenance, the fuel
tank, if mounted on engine, must be empty and the spark plug
side must be up. If the fuel tank is not empty and if the engine
is tipped in any other direction, it may be difficult to start due to
oil or gasoline contaminating the air filter and/or the spark plug.
Disconnect the spark plug wire/ battery at negative terminal before
starting maintenance activities. Avoid leaking of fuel (fire hazard)!

Cleaning of the water filters

6
Clean the water filters regular and remove possible dirt.

Maintenance at expense/DiBO technicians

7
For further maintenance we advise to contact your DiBo distributor concerning
a maintenance contract. The maintenance applies to normal company
circumstances. at heavy circumstances you can communicate this so that can
be taken into account. Supplement documents:
• Control manual
• CE- certificate
Remarks: It is recommend the preventive maintenance to carry out by a
competent DiBo- service technician according to this maintenance diagram,
to be able to remain use the machine up to maximum and also to be able to
claim the guarantee conditions. To be able to guarantee a good and regular
maintenance, we advise the owner/user at strongest to make an appointment
with DiBo against reaching the given up company hours, concerning a
maintenance turn.

DESCRIPTION DAILY CONTROL

Frame

1
Check the frame in its entirety at loose bolts and/or cracks of the welds. keep
the machine as much as possible clean to prevent act on dirt, water, oil and
messed fuel.
DiBO 24