Technical Info; General; General Data; Accessories - Dibo PTL Mode D'emploi

TYPE (IRRESPECTIVE OF
ELECTRICAL START OR
MANUAL START)
PTL-M 200/18
PTL-M 250/13
PTL-L 350/16
PTL-L 500/14

Technical info

GENERAL

In this chapter you find the most important technical data of the range
where your machine belongs. possibly additional technical documentation
off your machine can be included as an annex under the chapter "Machine
documentation". Machine overzicht see end of book. "Technical data" on page
29 .

GENERAL DATA

• Maximum reactive force of the sprinklers: < 60n
• Minimum water pressure (at lp entrance): 200 kpa (2 bar)
• Maximum water pressure (at lp entrance): 300 kpa (3 bar)
• Minimum water temperature: 1 °C
• Maximum water temperature: see "Technical data" on page 29
• Sufficient water supply at drinking water quality (Directive 98/83/EG)
• The use of an extra water filter is recommended

ACCESSORIES

1 x user manual

VIBRATION MEASUREMENT (HAND/ARM) - ROTATING HEAD

as previously mentioned, when using the lance with rotating head of the
cleaner (note: not all cleaners have a lance with rotating head), the action values
will be reached sooner. Below, a table is mentioned with the vibration intensity
and exposure time (in hours) of the lances with rotating head on a weekly basis.
The measurements were carried out in the capacity of an accredited laboratory.
This measurements were carried out according to the Royal Decree of 7 July
2005 and En-ISo 5349:1
‘
Note: the version with reel reduces the vibration exposure
time. Increasing the water temperature (for ex.: through the
hotbox) does not raises the vibration exposure time.
VIBRATION INTENSITY
(AEQSUM)
12.6 m/s²
8.9 m/s²
0.3 m/s²
na
DiBO 27
EXPOSURE TIME (ACTION)
ON WEEKLY BASE
1.34 h
3.10 h
+ 40 h
na
T E C h n I C a l I n F o
EXPOSURE TIME (LIMIT) ON
WEEKLY BASE
6.16 h
12.42 h
+ 40 h
NA
E N