Endress+Hauser Proservo NMS80 Manuel De Mise En Service page 260

Menu de configuration
P1 (bottom) source
Navigation
Description
Sélection
Réglage usine
Information
supplémentaire
P1 (bottom)
Navigation
Description
Information
supplémentaire
P1 (bottom) manual pressure
Navigation
Prérequis
Description
Entrée
260
Sous-menu "Pressure"
Navigation  Setup → Advanced setup → Application → Tank configuration
 Setup → Advanced setup → Application → Tank configuration → Pressure → P1
(bottom) source
Defines the source of the bottom pressure (P1).
• Manual value
• HART device 1 ... 15 pressure
• AIO B1-3 value
• AIO C1-3 value
• AIP B4-8 value
• AIP C4-8 value
Manual value
Accès en lecture
Accès en écriture
 Setup → Advanced setup → Application → Tank configuration → Pressure → P1
(bottom)
Shows the pressure at the tank bottom.
Accès en lecture
Accès en écriture
 Setup → Advanced setup → Application → Tank configuration → Pressure → P1
(bottom) manual pressure
P1 (bottom) source (→  260) = Manual value
Defines the manual value of the bottom pressure (P1).
–25 ... 25 bar
→ Pressure
Operator
Maintenance
Operator
-
Proservo NMS80


Endress+Hauser