Proservo NMS80
Modbus address
Navigation
Prérequis
Description
Entrée
Réglage usine
Information
supplémentaire
Float swap mode
Navigation
Prérequis
Description
Sélection
Réglage usine
Information
supplémentaire
Bus termination
Navigation
Prérequis
Description
Sélection
Endress+Hauser
Setup → Advanced setup → Communication → Modbus X1-4 → Configuration
→ Device ID
Communication interface protocol (→ 231) = MODBUS
Defines the Modbus address of the device.
1 ... 247
1
Accès en lecture
Accès en écriture
Setup → Advanced setup → Communication → Modbus X1-4 → Configuration
→ Float swap mode
Communication interface protocol (→ 231) = MODBUS
Sets the format of how the floating point value is transfered on Modbus.
• Normal 3-2-1-0
• Swap 0-1-2-3
• WW Swap 1-0-3-2
Swap 0-1-2-3
Accès en lecture
Accès en écriture
Setup → Advanced setup → Communication → Modbus X1-4 → Configuration → Bus
termination
Communication interface protocol (→ 231) = MODBUS
Activates or deactivates the bus termination at the device. Should only be activated on the
last device in a loop.
• Off
• On
Operator
Maintenance
Operator
Maintenance
Menu de configuration
233