Endress+Hauser Proservo NMS80 Manuel De Mise En Service page 210

Menu de configuration
Entrée
Réglage usine
Information
supplémentaire
Probe position
Navigation
Prérequis
Description
Entrée
Réglage usine
Information
supplémentaire
Damping factor
Navigation
Prérequis
Description
Entrée
Réglage usine
Information
supplémentaire
210
–213 ... 927 °C
250 °C
Accès en lecture
Accès en écriture
 Setup → Advanced setup → Input/output → Analog IP → Probe position
Operating mode (→  206) = RTD temperature input
Position of the temperature probe, measured from zero position (tank bottom or datum
plate). This parameter, in conjunction with the measured level, determines whether the
temperature probe is still covered by the product. If this is no longer the case, the status of
the temperature value will be ' i nvalid' .
–5 000 ... 30 000 mm
5 000 mm
Accès en lecture
Accès en écriture
 Setup → Advanced setup → Input/output → Analog IP → Damping factor
Operating mode (→  206) ≠ Disabled
Defines the damping constant (in seconds).
0 ... 999,9 s
0 s
Accès en lecture
Accès en écriture
Operator
Maintenance
Operator
Maintenance
Operator
Maintenance
Proservo NMS80


Endress+Hauser