Menu de configuration
Gauge command 0
Navigation
Prérequis
Description
Sélection
Réglage usine
Information
supplémentaire
Gauge command 1
Navigation
Prérequis
Description
Sélection
228
Setup → Advanced setup → Input/output → Digital input mapping → Gauge
command 0
Digital input source 1 (→ 227) ≠ None
Gauge command assigned to digital input combination 0 (DI2=0, DI1=0).
• Stop
• Level
• Up
• Bottom level
• Upper I/F level
• Lower I/F level
• Upper density
• Middle density
• Lower density
• Repeatability
• Water dip
• Release overtension
• Tank profile
• Interface profile
• Manual profile
• Level standby
Level
Accès en lecture
Accès en écriture
Setup → Advanced setup → Input/output → Digital input mapping → Gauge
command 1
Digital input source 1 (→ 227) ≠ None
Gauge command assigned to digital input combination 1 (DI2=0, DI1=1).
• Stop
• Level
• Up
• Bottom level
• Upper I/F level
• Lower I/F level
• Upper density
• Middle density
• Lower density
• Repeatability
• Water dip
• Release overtension
Operator
Maintenance
Proservo NMS80
Endress+Hauser