Replacing Components; Instructions For Use - MBM FTE74A Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
in "Starting production".
In order to free air in the pipes,
open the network lock, turn the
knob of the appliance while pressing it
in the piezoelectric position, place a
flame (match or the likes) on the pilot
light and wait for it to ignite.
DAILY DECOMMISSIONG / Upon
completion of the operations descri-
bed above:
1. Close the network locks upstream the
appliance (Water - Gas - Electric).
2. Make sure that the drain cocks (if
present) are "Closed".
3. Check the cleanliness and hygiene
of the appliance.
PROLONGED DECOMMISSIONING
/ In case of prolonged inactivity, per-
form all the procedures described for
daily putting out of service and protect
the parts most exposed to oxidation
as indicated below:
CONTACT AUTHORIZED TECHNICAL ASSISTANCE AND CON-
SULT THE TECHNICAL MANUAL.
LOCATION OF MAIN COMPONEN-
TS - see SECT. IMAGES - REF. g)
The layout of the figures is purely indi-
cative and can undergo variations.
1. Indicator light (see Knobs, keys and
indicator light modes and functions).
2. Thermostat knob (see Knobs, keys
and indicator light modes and fun-
ctions).
3. Hotplate.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
OPERATIONS FOR COMMISSIONING
1. Use lukewarm water with a bit of
soap to clean the parts;
2. Rinse the parts thoroughly, without
using pressurized direct water or steam
cleaners jets for cleaning operations
3. Dry the surfaces carefully using
non-abrasive material;
4. Wipe a non-abrasive cloth lightly so-
aked with food-safe Vaseline oil over all
of the stainless steel surfaces in order
to create a protective film.
For appliances with doors and rubber
gaskets, leave the door slightly ajar to
let it air out and spread protective talcum
powder on the rubber gasket surfaces.
Periodically air the appliances and
rooms.
a year by an authorised technician of
the assistance service.

REPLACING COMPONENTS

INSTRUCTIONS FOR USE

4. Cooking oil/grease collection con-
tainer.
KNOBS, KEYS AND INDICATOR
LIGHT MODES AND FUNCTIONS
see SECT. IMAGES - REF. g).
The layout of the keys in the figures is
purely indicative and can be subject to
variations.
- 13 -
To make sure that the appliance
is in perfect technical conditions,
arrange for service at least once
5.
EN
6.
7.

Publicité

Table des Matières
loading

Table des Matières