Power Supply Connections - MBM FTE74A Manuel D'installation Et D'utilisation

of leveling and fixing operations for
the remaining equipment.
INTRODUCTION
(OPTIONAL) see SECT. IMAGES
- REF. c). / In order to introduce the
Before proceeding with the
operations, see "General sa-
fety information".
These operations must be per-
formed by qualified and au-
thorised operators, in accord-
ance with the laws in force and using
the appropriate materials described.
Generally the appliance is de-
livered without electric mains
supply cable, without pipes
for connection to the water, drain-
age and gas networks.
ELECTRICAL CONNECTION
Electrical connection should be per-
formed in compliance with the local
regulations in force, only by author-
ised and competent personnel.
the first instance, examine the data
shown on the technical data table of
this manual, on the serial plate and
on the electrical diagram.
Connect the equipment to an
overvoltage category III omnipo-
lar device.
EARTHING / It is essential to ear-
th the unit.To this purpose, it is ne-
cessary to connect to an efficient
earthing system the terminals marked
with the symbols placed on the line-recei-
ving terminal box. The earthing system
should comply with the local law in force.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
POSITIONING AND HANDLING
OF TERMINAL

POWER SUPPLY CONNECTIONS

In
- 10 -
terminal, position it and fix it with the
equipped screws provided (detail L1).
Once the described operations have
been carried out, position again the
panels and knobs of the different ap-
pliances in the respective housings.
SPECIFIC WARNINGS / The electrical
safety of this unit is assured only when
it is correctly connected to an efficient
earthing system as stated in the electri-
cal local safety regulations in force; the
Manufacturer declines any responsibility
for the non-compliance with these sa-
fety regulations.It is necessary to verify
this fundamental safety requisite and,
in case of doubt, ask for an accurate
testing of the system by professionally
qualifi ed personnel.
The Manufacturer cannot be deemed
responsible for any damages caused by
the lack of unit earthing.
Never interrupt the earth wire
(Yellow-Green).
CONNECTION TO THE DIFFE-
RENT ELECTRIC DISTRIBUTION
NETWORKS - see SECT. IMAGES
- REF. d)
If necessary, remove the terminal
box protection panel located on the
back of the machine.
The equipment is delivered to work with
the voltage indicated on the technical
label attached on the appliance.. Any
other connection is to be considered im-
proper and therefore dangerous.
It is mandatory to respect the
connection provided by the
manufacturer, visible on the connec-
tion label near the terminal board.
4.