Lenze Tmd Serie Instructions De Mise En Service page 19

Commissioning
Code
No. Name
Serial baud rate
Frequency setpoint via
keys or Modbus
Start condition
(with mains on)
Flying restart selection
Motor auto-calibration
6
Mode selection for c61
1
Present status/error
Last error
Last error but one
Last error but two
18
Possible Settings
Lenze Selection
0 0 LECOM: 9600 bps
Modbus: 9600,8,N,2
1 LECOM: 4800 bps
Modbus: 9600,8,N,1
2 LECOM: 2400 bps
Modbus: 9600,8,E,1
3 LECOM: 1200 bps
Modbus: 9600,8,O,1
0.0 0.0 {Hz}
1 0 Start after LOW-HIGH
change at terminal 28
1 Auto start if terminal 28 = HIGH
2 Flying restart (auto start disabled)
3 Auto start if terminal 28 = HIGH,
with flying restart
WARNING!
Automatic starting/restarting may cause damage to equipment and/or injury to personnel!
Automatic starting/restarting should only be used on equipment that is inaccessible to
personnel.
0 0 Search range: C11...0 Hz
1 Search range: last frequency...0 Hz
0 0 Calibration not done
1 Calibration enabled
2 Calibration complete
0 0 Monitoring only
1 Monitoring and editing
status/error message
error message
ENGLISH
IMPORTANT
• See C01
• LECOM if C01 = 0...3
• Modbus if C01 = 8...11
240 Only active if C01 is set properly
(C01 = 1, 5, 7, 9, 11)
See also c43 and c70
If c42 = 2 or 3, the controller will start the
motor speed search at C11, or at the last
output frequency before the fault, depending
on the setting of c43
• If C14 = 4...7, motor calibration must
be performed, but C86...C91 must be
programmed first (see C14)
• If motor calibration is attempted before
programming C86...C91, triggers
fault
c60 = 1 allows the keys
speed setpoint (c40) while monitoring c61
• Display
• Refer to Section 5 for explanation of status
and error messages
to adjust