Lenze Tmd Serie Instructions De Mise En Service page 14

Code
No. Name
Configuration -
Digital input E1
Configuration -
Digital input E2
Configuration -
Digital input E3
Configuration -
Digital input E4
Network address
C1
Minimum output
frequency
Maximum output
frequency
Acceleration time 1
Deceleration time 1
Possible Settings
Lenze Selection
1 1 Activate fixed setpoint 1 (JOG1)
2 Activate fixed setpoint 2 (JOG2)
3 DC braking (DCB)
4 Direction of rotation
2
5 Quick stop
6 CW rotation
7 CCW rotation
3
8 UP (setpoint ramp-up)
9 DOWN (setpoint ramp-down)
10 TRIP set
4
11 TRIP reset
12 Accel/decel 2
Note
A fault will occur under the following conditions:
• E1...E4 settings are duplicated (each setting can only be used once)
• One input is set to UP and another is not set to DOWN, or vice-versa
1 1
0.0 0.0 {Hz}
50.0 7.5 {Hz}
WARNING!
Consult motor/machine manufacturer before operating above rated frequency.
Overspeeding the motor/machine may cause damage to equipment and injury to
personnel!
5.0 0.0 {s}
5.0 0.0 {s}
ENGLISH
Commissioning
Activate JOG3: Both terminals = HIGH
see also C36
LOW = CW rotation
HIGH = CCW rotation
Controlled deceleration to standstill, active
LOW; Set decel rate in C13 or c03
CW rotation = LOW and CCW rotation =
LOW: Quick stop; Open-circuit protected
UP = LOW and DOWN = LOW: Quick stop;
Use momentary NC contacts
Active LOW, triggers
standstill)
NOTE: NC thermal contact from the motor
can be used to trigger this input
see also c70
see c01 and c03
247 Each controller on network must have
unique address
240 • Output frequency at 0% analog setpoint
• C10 not active for fixed setpoints or
setpoint selection via c40
240 • Output frequency at 100% analog setpoint
• C11 is never exceeded
999 • C12 = frequency change 0 Hz...C11
• C13 = frequency change C11...0 Hz
999
• For S-ramp accel/decel, adjust c82
IMPORTANT
(motor coasts to
13