About These Instructions - Lenze Tmd Serie Instructions De Mise En Service

About these instructions

This documentation applies to the Tmd vector frequency inverter, and contains important technical data
and describes installation, operation, and commissioning.
These instructions are only valid for Tmd frequency inverters with software rev 11 (see drive
nameplate).
Please read the instructions before commissioning.
A B
Type: ETMD152L4TXA
Id-No: 00000 000
Made in USA
IND CONT EQ
A Certifications
B Type
Scope of delivery
• 1 Tmd vector inverter (ETMD...)
with EPM installed (see Section 4.2)
• 1 Operating Instructions
© 2004 Lenze AG
No part of this documentation may be copied or made available to third parties without the explicit written approval of
Lenze AG.
All information given in this documentation has been carefully selected and tested for compliance with the hardware and
software described. Nevertheless, discrepancies cannot be ruled out. We do not accept any responsibility nor liability for
damages that may occur. Any necessary corrections will be implemented in subsequent editions.
2
C D
Input: Output:
3/PE
AC 400/480 V
4.8 / 4.0 A
50 / 60 Hz
C Input Ratings
D Output Ratings
Important
After receipt of the delivery, check immediately whether the items
delivered match the accompanying papers. Lenze does not accept
any liability for deficiencies claimed subsequently.
Claim
• visible transport damage immediately to the forwarder.
• visible deficiencies/incompleteness immediately to your Lenze
representative.
ENGLISH
For detailed information refer to
3/PE
instruction manual TD03
AC 400/480 V
4.1 / 3.4 A
1.5 kW
004605460364930305
0 - 240 Hz
ETMD152L4TXA000XX XX
E Hardware Version
F Software Version
E F
Tmd011