Safety Information; Pictographs Used In These Instructions - Lenze Tmd Serie Instructions De Mise En Service

Safety information

Operation
Systems including controllers must be equipped with additional monitoring and protection devices according
to the corresponding standards (e.g. technical equipment, regulations for prevention of accidents, etc.).
You are allowed to adapt the controller to your application as described in the documentation.
DANGER!
• After the controller has been disconnected from the supply voltage, live components
and power connection must not be touched immediately, since capacitors could be
charged. Please observe the corresponding notes on the controller.
• Do not continuously cycle input power to the controller more than once every three
minutes.
• Please close all protective covers and doors during operation.
Note for UL approved system with integrated controllers
UL warnings are notes which apply to UL systems. The documentation contains special information
about UL.
• Suitable for use on a circuit capable of delivering not more than 5000 rms
symmetrical amperes, 240 V maximum (240 V devices) or 500 V maximum
(400/500 V devices) respectively
• Use minimum 75 °C copper wire only.
Warnings!
• Shall be installed in a pollution degree 2 macro-environment.
1.1

Pictographs used in these instructions

Pictograph Signal word
DANGER!
WARNING!
4
Warning of Hazardous Electri-
cal Voltage.
Impending or possible danger
for persons.
Possible damage to equipment
NOTE Useful tip: If observed, it will
make using the drive easier
Meaning
ENGLISH
Consequences if ignored
Reference to an imminent
danger that may result in death
or serious personal injury if the
corresponding measures are
not taken.
Death or injury.
Damage to drive system or its
surroundings.