Lenze Tmd Serie Instructions De Mise En Service page 16

Code
No. Name
Current limit
Accel boost
Configuration -
analog input
C
Voltage - DC injection
brake (DCB)
Fixed setpoint 1
(JOG 1)
Fixed setpoint 2
(JOG 2)
Fixed setpoint 3
(JOG 3)
Frequency setpoint
Torque setpoint/range
C
Output frequency
Motor voltage
DC bus voltage
Motor current
Controller load
C
Motor torque
Heatsink temp
Possible Settings
Lenze Selection
200 30 {%}
Reference: Tmd rated output current
0.0 0.0 {%}
0 0 0...10 V
1 0...5 V
2 -10...+10 V
3 0...20 mA
4 4...20 mA
5 4...20 mA monitored
WARNING!
When running with -10...+10V reference (C34=2), a loss of reference will result in 5%
motor speed (0.05xC11).
Note
When C34 = 2:
• Rotation is determined by the polarity of the -10...+10 V signal:
+0.1...+10 V = CW and -0.1...-10 V = CCW (all other rotation commands are disabled)
• C11 sets maximum frequency in both directions (C10 is not active)
• CE1...CE4 = 6 or 7 will only start the controller, not select rotation
4.0 0.0 {%}
20.0 0.0 {Hz}
30.0 0.0 {Hz}
40.0 0.0 {Hz}
0.0 {Hz}
100 0 {%}
0.0 {Hz}
0 {V}
0 {V}
0.0 {A}
0 {%}
0 {%}
0 {C}
ENGLISH
Commissioning
200 • When the limit value is reached, either the
acceleration time increases or the output
frequency decreases
• When c73 = 0, max setting is 167%
20.0 Accel boost is only active during acceleration
• Voltage reference applied to 8U
• Tmd does not provide -10 V supply for
C34 = 2
• C34 = 2 disabled in vector torque mode
• Current reference applied to 8I
• C34 = 5 will trigger
below 2 mA
50.0 • See CE1...CE4 and c06
• Confirm motor suitability for use with DC
braking
240 Lenze setting: active at E1 = HIGH
240 Lenze setting: active at E2 = HIGH
240 Lenze setting: active at E1 = HIGH and E2
= HIGH
240 Display: Setpoint via analog input, function
UP/DOWN, or LECOM
400 • When C14 = 5 and C01 = 1, 5, 7, 9, 11,
sets the torque setpoint
• When C14 = 5 and C01 = 0, 2, 4, 6, 8, 10,
sets the torque range for C34
240 Display
999 Display
999 Display
400 Display
255 Display
400 Display: vector mode only (C14 = 4, 5)
255 Display
IMPORTANT
fault if signal falls
15