Technical Data; Before Commissioning; Attachment And Operation - Scheppach 5903703901 Traduction Des Instructions D'origine

• Injuries due to defective cutting wheel. Check the
integrity of the cutting wheel regularly.
• Danger of injury for fingers and hands when chang-
ing the cutting wheel. Wear suitable work gloves.
• Danger of injury when the machine is switched on
from the running cutting wheel.
• Hazard due to electrical power with the use of im-
proper electrical connection cables.
• Danger to health from running cutting wheel due to
long hair and loose clothing. Wear personal protec-
tive equipment such as a hair net and close-fitting
work clothing.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety in-
structions" and the "Proper use" are observed along
with the whole of the operating instructions.

6. Technical data

Dimensions L x W x H
Cutting wheel Ø
Idle speed
Weight
Cutting data
Min. workpiece size
Max. workpiece size
Drive
Engine
Rated input P1
Protection class
Noise level
The noise values have been determined in accordance
with EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
26 | GB
620 x 270 x 605 mm
355 x 25.4 x 3 mm
4200 rpm
12.9 kg
ø 15, 15 x 15 mm
ø 115, 137 x 100 mm
220-240 V~ / 50 Hz
2600 W
II
98 dB(A)
3 dB
109 dB(A)
3 dB
www.scheppach.com
Wear hearing protection.
Excessive noise can result in a loss of hearing. Total
vibration values (vector sum of three directions) deter-
mined according to EN 62841.
• The specified noise emission values have been
measured in accordance with a standardised test
procedure and can be used to compare one power
tool with another.
• The specified noise emission values can also be
used for an initial estimation of the exposure.
• Warning:
The noise emission values can vary from the spec-
ified values during the actual use of the power tool,
depending on the type and the manner in which the
power tool is used, and in particular the type of work-
piece being processed.
• Implement measures to protect against noise nui-
sance. In doing so, take into account the complete
working process, including the times when the
power tool is working without load or switched off.
Suitable measures include regular maintenance and
care of the power tool and the insertion tools, regu-
lar breaks as well as proper planning of the working
process.
7.

Before commissioning

• Unpack the metal cutting machine and check for any
transport damage
• The machine must be securely installed.
• Prior to commissioning, all covers and safety devic-
es must be mounted correctly.
• The cutting wheel must be able to run freely.
• Before pressing the on/off switch, make sure that
the cutting wheel is correctly fitted and that moving
parts run smoothly.
• Before connecting the machine, make certain that
the data on the type plate matches with the mains
power data.

8. Attachment and operation

Attention! Remove the mains plug before any
maintenance, modification and assembly work.
Transport lock / carrying handle (Fig. 2)
To put the machine into the work position from the
transport position, proceed as follows:
1. Press the machine head (12) on the handle (15)
down and hold it in this position.