Technical Data - Scheppach PL55Li Traduction Des Instructions D'origine

• Harmful/poisonous dust can arise during work
(e.g. paint containing lead and some types of
wood). Touching or inhaling this dust can pose a
risk to the operator or persons in close proximity.
Observe the safety instructions applicable in your
country.

6. Technical Data

Motor voltage
Idling speed n
0
Saw blade angled position
Depth of cut 0°
Depth of cut 45°
Saw blade dimensions
Weight (without rechargeable bat-
tery)
Emission values
The values determined according to EN 60745 are
typically:
Sound pressure level L
PA
Sound power level L
WA
Uncertainty K
CAUTION
Hearing damage when working with noise
Use hearing protection!
Vibration emissions value ah (vector sum, three direc-
tions) and uncertainty K determined per EN 60745:
Vibration emissions value a
Uncertainty K
The specified emissions values (vibration, noise)
• facilitate the machine comparison,
• are also suitable for a provisional estimation of the
vibration and noise pollution during use,
• represent the main applications of the electrical
tool.
Increase possible with other applications, with other
tools and in case of inadequate maintenance. Ob-
serve idle running and standstill times of the machine!
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
36 V
4300 min
-1
0-45°
55 mm
41 mm
160x20 mm
5,3 kg
92 dB(A)
103 dB(A)
3 dB(A)
3,24 m/s
2
h, W
1,5 m/s
2
7. Commissioning
Inserting the rechargeable battery (Fig. 3)
Push a rechargeable battery (7) approved for the de-
vice into the retainer, until it latches.
Battery charge level (Fig. 2)
Press the battery symbol on the capacity display (8)
to display the charge level of the rechargeable bat-
tery (7).
Removing the rechargeable battery (Fig. 2)
In order to remove the rechargeable battery (7), press
the two unlock buttons (14) and draw the battery (7)
out of the device.
Setting the cutting depth
The cutting depth can be set at the cutting depth stop
(9) between 0 - 55 mm.
The saw unit can now only be pressed down to the
set cutting depth.
Cutting depth without guide rail:
Cutting depth with guide rail:
Setting the cutting angle between 0° and 45°:
• Open the knobs (5)
• Pivot the saw unit to the desired cutting angle.
• Close the knobs (5)
• The two positions (0° and 45°) are set in the factory.
Replacing the saw blade
m ATTENTION! Remove the rechargeable bat-
tery before changing the saw blade. Wear gloves
when handling saw blades
1. Slide the switch lock (2) to the OFF position.
2. Press the handles (1) sufficiently far down that the
saw unit latches.
3. Actuate the shaft interlock (15) and turn the saw
blade (12) until it latches.
4. Open the flange screw with the wrench provided.
5. First remove the saw blade flange (13) and then
the saw blade (12).
6. Insert the new saw blade (12) and the saw blade
flange (13) again. m ATTENTION! Observe the
direction of rotation of the saw blade.
7. Insert the flange screw again and firmly tighten it.
8. Return the saw to its initial position by pushing the
switch lock (2) into the ON position.
max. 55 mm
max. 49.5 mm
GB | 21