Technical Data - Scheppach BASA3 Traduction Des Instructions D'origine

• Danger of injury for fingers and hands when chang-
ing the saw band. Wear suitable work gloves.
• Danger of injury when the machine is switched on
from the running saw band.
• Hazard due to electrical power, with the use of im-
proper electrical connection cables.
• Danger to health from running saw band due to long
hair and loose clothing. Wear personal protective
equipment such as a hair net and close-fitting work
clothing.
• The rollers can continue to rotate if a drive belt or a
saw blade breaks. Always wait for the machine to
come to a complete stop before opening the sepa-
rating guards.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety gen-
eral instructions" and the "Proper use" are observed
along with the whole of the operating instructions.

6. Technical data

Max. admission width
Max. admission height
Table size
Cutting speed
Saw band length
Height up to tabletop
Height up to tabletop with ma-
chine stand
Total height without
Machine stand
Total height with
Machine stand
Overall width
Total depth
Table pivot range
Tisches
Weight (230-240V)
Weight (400V)
Extraction connection
Max. installation altitude
(above sea level)
Drive
Engine
Nominal consumption P1 (kW)
Power output P2 (kW)
Drive
Engine
Nominal consumption P1 (kW)
Power output P2 (kW)
*Operating mode S1 (continuous operation)
The machine can be operated continuously with the
specified power.
*Operating mode S6 40 %
306 mm
Continuous duty with intermittent loading (operating
205 mm
time 10 min.)
400 x 548 mm
To avoid impermissible overheating of the motor, the
motor should be driven for only 40% of the operating
370 – 750 m/rpm
time with the stipulated nominal power and must then
2360 mm
continue to run with no load for the remaining 60% of
490 mm
the operating time.
1025 mm
Technical changes reserved!
The workpiece must have a minimum height of 3 mm
1125 mm
and a minimum width of 10 mm.
1655 mm
Noise data
The noise level defined in EN ISO 3746 and EN 1807
900 mm
respectively (correction factor k3 calculated in acc.
540 mm
with Appendix A.2 of EN 1807-1) for the noise emission
values determined for workplace noise level reflect the
-11° – +45°
workplace conditions defined in ISO 7960 Appendix J.
The stipulated values are emission values and so do
Approx.
not necessarily represent safe working values.
78.4/84.4kg
Although there is a correlation between emission levels
Approx.
and exposure levels, it is not possible to reliably de-
74.5/80.5kg
termine whether additional protective measures will be
Ø 100 mm
required or not based on this.
1000 m
www.scheppach.com
AC
230-240V~ 50 Hz
0.8kW (S1)
1.1 kW (S6 40%)
0.56 kW (S1)
0.74kW (S6
40%**)
Three-phase cur-
rent 400V
3 phases ~ 50 Hz
0.7kW (S1)
1.1 kW (S6 40%)
0.48 kW (S1)
0.77kW (S6
40%**)
GB | 39