Scheppach BASA3 Traduction Des Instructions D'origine page 37

g) If devices are provided for the connection of
dust extraction and collection facilities, en-
sure these are connected and properly used.
Use of dust collection can reduce dust-related
hazards.
h) Do not let familiarity gained from frequent use
of tools allow you to become complacent and
ignore tool safety principles. A careless action
can cause severe injury within a fraction of a sec-
ond.
4. Power tool use and care
a) Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at the
rate for which it was designed.
b) Do not use the power tool if the switch does
not turn it on and off. Any power tool that can-
not be controlled with the switch is dangerous and
must be repaired.
c) Disconnect the plug from the power source
and/or remove the battery pack, if detachable,
from the power tool before making any adjust-
ments, changing accessories, or storing pow-
er tools. Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of chil-
dren and do not allow persons unfamiliar with
the power tool or these instructions to operate
the power tool. Power tools are dangerous in the
hands of untrained users.
e) Maintain power tools and accessories. Check
for misalignment or binding of moving parts,
breakage of parts and any other condition that
may affect the power tool's operation. If dam-
aged, have the power tool repaired before use.
Many accidents are caused by poorly maintained
power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the power
tool for operations different from those intended
could result in a hazardous situation.
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unexpected
situations.
5. Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
m WARNING
Danger due to electromagnetic field
This power tool generates an electromagnetic field dur-
ing operation. This field can impair active or passive
medical implants under certain conditions.
- In order to prevent the risk of serious or deadly
injuries, we recommend that persons with medi-
cal implants consult with their physician and the
manufacturer of the medical implant prior to op-
erating the power tool.
Additional safety instructions
• Wear safety goggles and hearing protection when
working for your personal protection. Wear a hair
net with long hair. Roll loose sleeves up above the
elbows.
• Always wear a mask or a dust mask.
• Do not operate this tool in the vicinity of highly flam-
mable liquids or gases.
• Carefully check the saw bands before use for cracks
or other damage. Replace saw bands with cracks or
other damage immediately.
• Only use saw bands recommended by the manufac-
turer which conform to the standard EN847-1.
• Only use the recommended accessories in these
instructions. The use of unsuitable accessories can
lead to injuries.
• Select a saw band suitable for the material to be cut.
• Do not use saw bands made of HSS steel.
• Make sure that the saw band is always clean and
sharp in order to minimise the noise level.
• Do not cut metallic objects such as nails or screws.
Inspect the workpiece for nails, screws and other
foreign objects and remove them before starting
work, if necessary.
• Remove screwdrivers, saw waste etc. from the table
before switching the tool on.
www.scheppach.com GB | 37