EDELRIDe LOOPO LITE Mode D'emploi page 9

As a general rule, PPE products must be replaced immediately if,
for instance, products with straps have frayed edges or if fi bres
are torn out of the weave, if the stitching shows signs of damage
and/or abrasion or if the product has been in contact with
chemicals.
Ropes or products with ropes must be replaced immediately if
they have been involved in an extreme fall (fall factor >1) or if the
sheath has been damaged (so that the core is visible) or if it has
been in contact with chemicals.
Repairs may only be carried out in accordance with procedures
recommended by the manufacturer.
STORAGE, TRANSPORT AND CARE
Storage: Store in a cool, dry, dark place outside transport con-
tainers. Avoid contact with chemicals (caution: battery acid!)
Store without mechanical stress caused by jamming, pressure or
tension.
Transport: The product must be kept away from direct sunlight,
chemicals, dirt and mechanical damage. For this purpose, a pro-
tective bag or special storage and transport containers should
be used.
Cleaning: Fig 4.
If required, halogen-free commercial disinfectants may be used.
If required, hinges of metal parts may be oiled after cleaning.
Warning! Failure to follow these instructions may endanger life!
PRODUCT ILLUSTRATIONS
Tying-in with sit harness:
1. The rope is tied directly to the tie-in loop/tie-in eyelet (A)
(fi g. 5a, 5c).
2. The rope is fed underneath the leg loop connection and then
through both the tying-in loop and the hip belt before the knot
is made (fi g. 5b).
Tying-in with chest harness: (Fig.6)
The two tie-in loops of the chest harness are connected with
the tie-in loop of the leg loops (fi g. 6). For this purpose, a piece
of rope according to EN 892, single rope or EN 1891 is used. The
lower connecting knot (V) should be on the level of the breast-
bone. Tying-in is done by a tie-in knot (A) through the both loops
of the connection between chest and sit harness.
Tie-in knot: Figure-of-eight knot (fi g. 7a)
Connecting knot: Basic overhand knot (fi g. 7b)
Tying-in with fullbody harness: Fig. 8
PRODUCT INFORMATION FOR THIS ITEM:
Manufacturer: EDELRID
Model
Product description: safety harness according to
EN 12277, type
Lot number
Illustration of adjustable parts
CE 0123: the authority supervising production of PPE
(TÜV SÜD Product Service GmbH, 80339 Munich, Germany)
i-Symbol: Warning notices and instructions must be read and
observed
Year of manufacture
Remarks: Instruction for use: CE XXXX: notified authority which
is responsible for controlling and issuing the EC-Type Approval
Certificate of the product.
Technical Datasheet: Lot number with year of construction.
Our products are manufactured with the utmost care. However,
should any of our products give cause for a justifi ed complaint,
please advise us of the lot number.
We reserve the right to make technical amendments.