Maintenance; Disposal; Contact - EUFAB Bike Lift Manuel De L'opérateur

Masquer les pouces Voir aussi pour Bike Lift:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance

Before each journey, check the bicycle carrier for
wear. Defective metal parts and tension belts in
particular must be replaced.
To replace the parts, contact our customer service.
Any change to original parts and materials or to the
structure of the bicycle carrier may impair safety and
performance.
The steel parts of the bicycle carrier have been
protected from corrosion by powder coating in the
factory. If this layer of paint is damaged, ensure that
the damage is rectified professionally as soon as
possible.
Under normal conditions, the bicycle carrier requires
only cleaning and is otherwise maintenance-free.
Adjusting the quick-release mechanism
Perform this maintenance only if the bicycle carrier
cannot be fitted firmly on the tow hitch as described
in the chapter on Fitting.
 Remove the bicycle carrier from the tow hitch,
as described under Removal.
 Pull off the protective dust cap.
 Loosen the locknut a little, as shown in the
illustration.
 Tighten the adjusting screw by a quarter turn.
 Tighten the locknut.
 Check that the carrier is now sitting firmly on
the tow hitch, as described under Fitting. If not,
repeat the steps described above.
Maintenance / Disposal / Contact

Disposal

Observe the local official regulations for disposal.
Also, dispose of the packaging by type in the
collection containers provided for this.
More information can be obtained from your local
waste disposal centre.

Contact

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
GERMANY
Telephone: +49 (0) 202 - 429283-0
Fax:
+49 (0) 202 - 429283-20
Email:
info@eal-vertrieb.com
GB
45

Publicité

Table des Matières
loading

Table des Matières