Optional Accessories; Specified Conditions Of Use - Corghi HD 1300 Manuel D'utilisation

The bead lifting lever is used to demount the tyre from the rim
- Set of 4 stems with 56" clamps
The set of 4 clamp stems is used for rims without cover or that have a diameter greater
than 36". The maximum operating capacity is 56".

OPTIONAL ACCESSORIES

Please refer to the relevant accessories catalogue.

SPECIFIED CONDITIONS OF USE

The HD1300 tyre changer was designed exclusively for tyre mounting and demounting.
Any use of the machine other than the described use is to be considered as improper
and unreasonable.
The manufacturer does not intend the machine to be used for inflation operations.
If the operator decides to proceed with partial bead insertion in the tyre on the ma-
chine using his own equipment, a pressure of 0.5 bar must NOT be exceeded (unless
the tyre manufacturer does require lower pressure levels). In any case, the current
standards in force in the country where the tyre changer is used must be observed.
Use only original CORGHI equipment and accessories.
The figure shows the safety distances and
the positions used by the operator during
the various work phases:
A Positioning the wheel on the turntable
B Inner bead breaking
C Outer bead breaking, demounting and
mounting.
86
CAUTION!
DANGER
CAUTION!
1500
HD 1300 / HD 1300 A Operator Manual
2000
A
C
B
10