Clamping The Wheel - Corghi HD 1300 Manuel D'utilisation

CLAMPING THE WHEEL

The machine has a high pressure hydraulic
circuit for the movements.
The pressure in this circuit can be adjusted
by turning the handle (A, Fig. 17) as explained
in the table.
pressure adjustment range .. 60 to 100 bar
normal operating pressure ............ 100 bar
The pressure at which the machine is set can
be checked on the pressure gauge (C, Fig. 11)
by operating the turntable open control to its end of stroke or by locking a rim.
If the machine malfunctions, retreat to a safe distance and turn the machine's main
switch (A, Fig. 11) to 0.
Make sure that the rim is correctly and firmly locked on every gripping point of the
turntable clamp.
Any operation intended to modify the setting value of the relief valves is forbidden.
The manufacturer declines all liability for damage resulting from tampering with
these valves.
HD 1300 / HD 1300 A Operator Manual
CAUTION!
CAUTION!
CAUTION!
A
17
EN
91