Corghi HD 1300 Manuel D'utilisation page 70

8. Risk of crushing. Presence of moving parts. Contact with
moving parts could result in an accident.
• The machine may only be used by one operator at a time.
• Keep other people away from the tyre changer.
• Keep your hands and fingers away from the rim edge dur-
ing the demounting and mounting process.
• Keep your hands and fingers away from the mounting tool during operation.
• Keep your hands and fingers away from the bead breaker disc during its
operation.
• Keep your hands and other body parts away from moving parts.
• Do not use tools other than those supplied with the tyre changer or original
CORGHI accessories.
• Use lubricant that is specific for tyres in order to prevent tyre seizure.
• Pay attention while handling the rim and tyre and while using the lever
9. Hazard of electric shock.
• Do not clean the electric parts with water or high pressure
air jets.
• Do not operate the machine with a damaged power cord.
• If an extension is necessary, use a cable with nominal fea-
tures equal to or greater than those for the machine. Cables
with nominal features that are lower to those of the machine could overheat
and cause a fire.
• Make sure that the cable is positioned so that no one will trip over it and it
cannot be pulled.
10. Hazard of eye injuries. During the bead insertion and inflation phase, debris,
dust and fluids could be projected into the air. Remove any
debris present in the tread of the tyre and on the tyre surface.
Wear protective goggles with OSHA, CE approval or other
certified devices during all work phases.
11. Always carefully inspect the machine before using it. Missing,
damaged or worn equipment (including the hazard labels)
must be repaired or replaced before start-up.
12. Never leave nuts, bolts, tools or other materials on the machine. They could
remain trapped in moving parts and cause malfunctions or be projected out
of the machine.
13. DO NOT install tyres that are cut, damaged, decayed or worn. DO NOT mount
tyres on bent, rusted, worn, warped or otherwise damaged rims.
14. If the tyre is damaged during the mounting phase, do not try to complete
the mounting operation. Remove it and take it away from the service area,
marking it as damaged.
15. The internal parts in this machine could create contacts or sparks if exposed
to flammable vapours (petrol, paint thinner, solvents, etc.). Do not install the
machine in a narrow area or below floor level.
16. Do not operate the machine while under the influence of alcohol, medicine
or drugs. If you are taking prescription or non-prescription medicine, contact
a physician to understand the side effects that the medicine could have on
the ability to operate the machine safely.
70
HD 1300 / HD 1300 A Operator Manual