Corghi HD 1300 Manuel D'utilisation page 105

Do not remove or change any part of the machine (except for maintenance purposes).
Before removing unions or pipes, make sure that the fluids are not pressurised. If pres-
surised oil escapes, it can cause serious injury.
Keep the working area clean.
Never use compressed air or water jets to remove dirt or residues from the machine.
When cleaning, take care not to create and raise dust as far as possible.
To make your machine last longer and per-
form better, it is recommended to:
- clean the turntable and the guide pins
once a week with environmentally friendly
solvents;
- grease (fig.40a-b) all the machine's mov-
ing parts at least once a month (see the
lubrication and greasing diagram);
API PGX0 GREASE
Alternatively
IP ATHESIA PGXO – PGX
AGIPGREASE PGX 0
- clean the filter cartridge approx. every 1500
HD 1300 / HD 1300 A Operator Manual
CAUTION!
CAUTION!
WARNING
hours of operation;
- check the oil level in the control unit (see
the lubrication and greasing diagram) (fig.
40c) and top up with oil if necessary, AGIP
OSO 32 or another equivalent type (this
check must be performed with the cylinders
"closed"): it is recommended to replace the
oil in any case after 1500 hours of operation
or once a year.
40b
EN
40a
105