Installing The Refrigerator - GE PVD Serie Manuel Du Propriétaire Et Instructions D'installation

Installation Instructions

INSTALLING THE REFRIGERATOR

REFRIGERATOR LOCATION
it will not run often enough to maintain proper
temperatures.
it will not perform properly.
to water (rain, etc.) or direct sunlight.
Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following clearances for ease of
installation, proper air circulation and plumbing and
electrical connections.
REMOVING THE REFRIGERATOR
DOORS
IMPORTANT NOTE:
(943 mm) deep (refer to chart on previous page).
in order to leave the doors and handles attached
to the refrigerator while transporting it into the
installation location. If passageways are less
handles can easily be scratched and damaged.
The top cap and doors can be removed to allow
the refrigerator to be safely moved indoors. If
start with Step 1.
If it is not necessary to remove doors, skip to Step
11. Leave tape and all packaging on doors until the
refrigerator is in the final location.
NOTE:
refrigerator. Place the refrigerator on the hand
truck with a side against the truck. We strongly
recommend that TWO PEOPLE move and
complete this installation.
24
1 REMOVE THE REFRIGERATOR
AND FREEZER DOOR HANDLES
(if necessary)
Handle design varies; however installation is the
same.
Leave film on door until installation is finished.
wrench.
Mounting
Mounting
49-1000332 Rev. 0