GE PVD Serie Manuel Du Propriétaire Et Instructions D'installation page 29

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
CONNECTING THE REFRIGERATOR TO THE HOUSE WATER LINE
12
A cold water supply is required for automatic
ice maker operation. If there is not a cold water
supply, you will need to provide one. See
Installing the Water Line section.
NOTES:
• Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
• If your refrigerator does not have a water
filter, we recommend installing one if your
water supply has sand or particles that
could clog the screen of the refrigerator's
water valve. Install it in the water line near
the refrigerator. If using SmartConnect
additional tube (WX08X10002) to connect the
• Before connecting the water line to the house,
purge the house line for at least 2 minutes.
If you are using copper tubing, place a
A
compression nut and ferrule (sleeve) onto the
end of the tubing coming from the house cold
water supply.
WARNING
NOT drill into the refrigerator.
49-1000332 Rev. 0
™
Electrical Shock Hazard.
If you are using the SmartConnect
nuts are already assembled to the tubing.
If you are using copper tubing, insert the end
B
of the tubing into the refrigerator connection, at
the back of the refrigerator, as far as possible.
While holding the tubing, tighten the fitting.
If you are using SmartConnect
insert the molded end of the tubing into the
refrigerator connection, at the back of the
refrigerator, and tighten the compression nut
until it is hand tight. Then tighten one additional
turn with a wrench. Over tightening may cause
leaks.
C
hold it in position. You may need to pry open
the clamp.
WARNING
Connect to potable water supply
only. A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 psi (275-827 kilopascals)
tubing, the
™
tubing,
™
SmartConnect
Tubing
(sleeve)
Refrigerator
Connection
™
29