Installing The Refrigerator; Removing The Refrigerator Doors - GE DFE Série Manuel D'utilisation Et Instructions D'installation

Installation Instructions

INSTALLING THE REFRIGERATOR

REFRIGERATOR LOCATION
it will not run often enough to maintain proper
temperatures.
it will not perform properly.
loaded.
CLEARANCES
Allow the following clearances for ease of
installation, proper air circulation and plumbing and
electrical connections.
REMOVING THE REFRIGERATOR
DOORS
IMPORTANT NOTE: This refrigerator is 36
(31
1 4
leading to the installation location must be at least
36
1 4
attached to the refrigerator while transporting it into
than 36
1 4
easily be scratched and damaged. The top cap and
doors can be removed to allow the refrigerator to be
31
1 4
11. Leave tape and all packaging on doors until the
refrigerator is in the final location.
NOTE:
refrigerator. Place the refrigerator on the hand
truck with a side against the truck. We strongly
recommend that TWO PEOPLE move and complete
this installation.
28
REMOVE THE FRESH FOOD
1
DOOR HANDLE
Stainless steel and plastic handles:
wrench and remove the handle.
NOTE:
wrench.
Mounting
FOR DOOR IN DOOR MODELS
1a
ONLY
1 4
To Remove the Handle:
Loosen the set screws as shown in Step 1.
To Install the Handle:
Align the lever with the opening on the outer
door. Make sure the hook is pointed up.
align the handle with the mounting fasteners.
Once the handle is flush with the outer door,
tighten the set screws.
installed
Latch
Allen
Leave film
on until after
installation
Latch Lever
with Hook
facing up.
49-60792-1