Truth Or Myth - GE DFE Série Manuel D'utilisation Et Instructions D'installation

Masquer les pouces Voir aussi pour DFE Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Truth or Myth

SERVICE
Truth or Myth
Truth or Myth?
The refrigerator water filter may require re-
placement prior to six months
The automatic ice maker in my refrigerator will
produce ice when the refrigerator is plugged
into a power receptacle.
After the refrigerator has been plugged in and
unlimited chilled water available from the
water dispenser.
After water dispenses, a few drops of water
are normal.
partment.
When the refrigerator is installed, or after re-
for five minutes.
To fill the ice bucket to the maximum capac-
installation.
mine if the filter requires replacement.
The top of the refrigerator doors will always be
aligned.
Refrigerator door handles can be easily tight-
ened.
There may be odor and taste problems with
your ice.
doors to align them.
48
Before you call for service, review the detailed troubleshooting tips in the Owner's manual.
800.GE.CARES 800.432.2737.
Answer
MYTH
MYTH
-
MYTH
-
MYTH
GEAppliances.ca or call 800.561.3344.
Explanation
The water filter indicator will indicate the need to replace the water
filter every six months or 170 gallons of water dispensed (select
the dispenser slows, or ice production decreases, the water filter
should be replaced, even though the filter indicator may not indicate
the need for replacement.
The refrigerator must be connected to water, and the ice maker
must be turned on. Make sure the ice maker is turned on, only after
the water line is connected and water is turned on. The ice maker
can be turned on off from the controls and ensure the ice maker
is on, as indicated on the refrigerator control panel. See About the
Automatic Ice Maker.
The water dispenser tank located inside the refrigerator stores water
for dispensing. The water in this tank requires 24 hours to chill after
installation. High usage conditions will not allow time for the water
to chill.
A few drops of water may fall from the dispenser, after the dispenser
slowly from the dispenser.
frost using a plastic spatula and towel, then check to ensure that no
closing. Check the refrigerator control panel to ensure the door
alarm is on.
A newly installed refrigerator or water filter contains air in the water
lines. Press the dispenser paddle and dispense cold water for at
least 5 minutes to remove air from the water line, and flush the filter.
allows ice to disperse within the ice bucket, which in turns calls on
the ice maker to produce additional ice. Normal ice production =
100 cubes in 24 hours.
the water filter bypass plug (provided with the refrigerator on some
normal with the bypass plug in place, replace the water filter.
Several things can affect the fresh food door alignment, including
door to access the screw.
handles.
After starting the ice maker, throw away 24 hours of ice production
to avoid odor and taste problems.
adjust the right hand door. The adjustment screw is located on the
GEAppliances.com or calling
49-60792-1

Publicité

Table des Matières
loading

Table des Matières