Installing The Refrigerator - GE GYE18J Manuel D'utilisation Et Instructions D'installation

INSTALLING THE REFRIGERATOR

REFRIGERATOR LOCATION
it will not run often enough to maintain proper
temperatures.
will not perform properly.
to water (rain, etc.) or direct sunlight.
loaded.
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
IMPORTANT NOTES
This refrigerator without the handles ranges from
your model (see dimension G on the previous page).
to leave the doors attached to the refrigerator
while transporting it into the installation location.
refrigerator doors can easily be scratched and
damaged. The doors can be removed to allow the
refrigerator to be safely moved indoors.
•
•
single fresh food door model, see Reversing the
•
•
see
• NOT necessary to remove doors, skip to
Page 31. Leave tape and all packaging on doors
until the refrigerator is in the final location. Once in
place, install door handles (see Steps 1 and 2).
• SKID REMOVAL: Tilt refrigerator to each side to
remove skid.
• NOTE: Use a padded hand truck to move this
refrigerator. Place the refrigerator on the hand
truck with a side against the truck. We strongly
recommend that TWO PEOPLE move and
complete this installation.
49-60805-1
Installation Instructions
(91.4 cm), the
Removing
ATTACH FRESH FOOD
1
HANDLE(S)
Attach the handle to the mounting fasteners
by aligning the slots on the handle with the
mounting fasteners. Slide the handle down until
NOTE:
procedure for both doors.
Mounting
ATTACH FREEZER HANDLE
2
Attach the handle to the mounting fasteners by
aligning the slots on the handle with the mounting
fasteners. Slide the handle to the right until you
Mounting
21