Water Filter - Xwf - GE GYE18J Manuel D'utilisation Et Instructions D'installation

Water Filter Cartridge - XWF
Water Filter Cartridge
The water filter cartridge holder is located in the
back upper-right corner of the fresh food refrigerator
compartment.
When to Replace the Filter
cartridge on the dispenser, the red filter light will start
blinking to tell you that you need to replace the filter soon.
while you are dispensing until the filter is replaced.
the door is open until the filter is replaced.
cartridge should be replaced every six months, or earlier
if the flow of water to the dispenser or icemaker
decreases.
Removing the Filter
one:
front tabs and gently pulling down.
2. Rotate the filter down.
3. Gently grasp the filter and slowly turn it
counterclockwise about a ¼ turn. The filter should
automatically release itself when you have rotated it far
enough to the left. A small amount of water may drip
down.
CAUTION
the filter cartridge may be ejected as it is removed. Use
caution when removing.
Filter Bypass Plug
To reduce the risk of property damage due to water
leakage, you MUST use the filter bypass plug when a
replacement filter cartridge is not available. Some models
do not come equipped with the filter bypass plug. To
Canada, call 800.561.3344. The dispenser and icemaker
will not operate without either the filter or bypass plug
installed. The bypass plug is installed in the same way as
a filter cartridge
WARNING
To reduce the risk associated with choking, do not allow children under 3 years of age
to have access to small parts during the installation of this product. The disposable filter cartridge should be
replaced every 6 months at the rated capacity, or sooner if a noticeable reduction in flow rate occurs.
filters only. Using GE Appliances-branded filters in GE Appliances and Hotpoint® refrigerators provides optimal
performance and reliability. GE Appliances filters meet rigorous industry standards for safety and quality that are
important for products that are filtering your water. GE Appliances has not qualified non-GE Appliances-branded
filters for use in GE Appliances and Hotpoint refrigerators and there is no assurance that non-GE Appliances-
branded filters meet GE Appliances standards for quality, performance and reliability.
If you have questions, or to order additional filter cartridges, visit our website at gewaterfilters.com or call GE
Appliances Parts and Accessories, 877.959.8688. (Canada 1.800.661.1616 or GEAppliances.ca/en/products/
parts-filters-accessories)
49-60805-1
(on some models)
Installing the Filter in a Bottom Freezer
Refrigerator
1. Open the filter cartridge
front tabs and gently pulling
down.
2. Line up the ports on the filter
with the ports on the filter
cartridge holder, and gently insert the filter.
3. Slowly turn the filter to the
filter, it will automatically adjust
itself into position. The filter
will move about a ¼ turn or 90
degrees, until the arrow on the
filter aligns with the arrow on the
filter cartridge holder.
4. Slowly push the filter up into the clips.
5. Close the filter cartridge housing by
gently pushing the lid upwards until
the tabs lock into place.
6. Run water from the dispenser for 2 gallons (7.6 liters)
or approximately 5 minutes to clear the system. Water
may spurt out and air bubbles may be visible during
sure the filter has been fully rotated to the right.
models) on the dispenser for three seconds.
Application Guidelines/Water Supply
0.5 gpm (1.89 lpm)
Water Supply Potable Water
Water Pressure 25-120 psi (172-827 kPa)
Water Temperature
Capacity 170 gallons (643.5 liters)
Sign-up for TEXT REMINDERS by texting REPLACE
to 70543.
11