Water Filter - GE PSB42 Manuel D'utilisation Et Instructions D'installation

Water Filter Cartridge
Water filter cartridge
The water filter cartridge is located behind the upper
cover at the top of the refrigerator.
When to replace the filter on models with a
replacement indicator light
There is a replacement indicator light for the water filter
cartridge on the dispenser. This light will turn orange to
tell you that you need to replace the filter soon.
The filter cartridge should be replaced when the
replacement indicator light turns red or if the flow of
water to the dispenser or icemaker decreases.
Removing the filter cartridge
one by slowly turning it to the left. Do not pull down on
the cartridge. A small amount of water may drip down.
NOTE: To reduce the risk associated with property
damage due to water leakage, read and follow
instructions before installation and use of this system.
plumbing codes.
WARNING
To reduce the risk associated with choking, do not allow children under 3 years of age to have access to
small parts during the installation of this product.
The disposable filter cartridge should be replaced every 6 months at the rated capacity, or sooner if noticeable
reduction in flow rate occurs.
For the maximum benefit of your filtration system, GE Appliances recommends the use of GE Appliances-branded
filters only. Using GE Appliances-branded filters in GE Appliances and Hotpoint refrigerators provides optimal
performance and reliability. GE Appliances filters meet rigorous industry NSF standards for safety and quality that are
important for products that are filtering your water. GE Appliances has not qualifed non-GE Appliances branded filters
for use in GE Appliances and Hotpoint refrigerators and there is no assurance that non-GE Appliances branded
filters meet GE Appliances standards for quality, performance and reliability.
If you have questions, or to order additional filter cartridges, visit our website at gewaterfilters.com or call
GE Appliances Parts and Acessories, 877.959.8688. In Canada, call 800.661.1616.
8
(On some models.)
Installing the filter cartridge
1 Fill the replacement cartridge with water from the
tap to allow for better flow from the dispenser
immediately after installation.
2 Line up the arrow on the cartridge and the cartridge
holder. Place the top of the new cartridge up inside
the holder. Do not push it up into the holder.
3 Slowly turn it to the right until the
cartridge it will automatically raise
itself into position. The cartridge
4
liters) (about three minutes) to clear the system and
prevent sputtering.
5 Press the Settings
press and hold the Water and Ice keys at the same
time for 3 seconds to reset filter.
NOTE: A newly installed water filter cartridge may cause
water to spurt from the dispenser.
Filter bypass plug
To reduce the risk of water damage due
to water leakage, you MUST use the filter
bypass plug in the following conditions:
form of home water filtration system
To obtain a free bypass plug, visit geappliances.com
installed in the same way as a filter cartridge.
The icemaker will not operate without the filter or filter
bypass plug.
Cartridge
Holder
geappliances.ca The bypass plug is
Filter
Bypass
Plug
49-1000364 Rev. 1