GE PSB42 Manuel D'utilisation Et Instructions D'installation page 20

STEP 1 REMOVE PACKAGING
WARNING
The refrigerator is much heavier at the top than at the
bottom—be careful when moving. When using a hand
truck, handle from the side only.
• Carefully cut banding at the top and bottom, remove
the outer carton.
• Slide out the back corner posts (2).
• Slide the carton off the top of the cabinet.
NOTE:
• The unit is secured to the skid with 4 slotted tie-
base channels in the tie-downs.
the skid.
NOTE:
• The support blocks on the bottom of the refrigeration
case must be removed
before the refrigerator is
taken off the skid or damage
will occur. Carefully tilt the
refrigerator and slide the
blocks out from beneath.
• Remove the toekick and set
aside for final installation.
• Lift the refrigerator off the
skid with an appliance dolly.
Handle from the sides.
STEP 2 MOVE THE
REFRIGERATOR INTO THE HOUSE
• Re-use the corner posts from the packaging to
protect stainless steel models. Run the appliance
dolly straps over the posts and under the handles.
• Leave the protective film on the refrigerator until
installation is complete. IMPORTANT: Never lift the
refrigerator by the handle or push against the grille
• Avoid laying the unit on its back or side to prevent
sealed system restrictions.
20
Installation Instructions
Tip Over Hazard.
Remove
Tie Down
STEP 3 INSTALL WATER LINE
WARNING
Connect to potable water supply
only. A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 psi (275-827 kilopascals).
WARNING
ELECTRIC SHOCK HAZARD
NOT drill into the refrigerator.
AVERTISSEMENT
Raccordez l'appareil à
une alimentation d'eau potable seulement. Une
alimentation d'eau froide est requise pour faire
fonctionner la machine à glaçons et le pichet à
remplissage automatique. La pression d'eau doit se
situer entre 40 et 120 psi. (275 à 827 kPa).
AVERTISSEMENT
ADVERTENCIA
Realice la conexión a un
suministro de agua potable únicamente. Se requiere
un suministro de agua fría para el funcionamiento
de la máquina de hielos automática y de la jarra de
llenado automático. La presión del agua deberá estar
entre 40 y 120 p.s.i. (275 – 827 kPa).
ADVERTENCIA
Adhiera la abrazadera de la tubería usando el agujero
existente únicamente. NO perfore el refrigerador.
• A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 p.s.i. (275-827 kPa).
tubing between house cold water line and the water
connection location.
• The tubing should be long enough to extend to the
front of the refrigerator. Allow enough tubing to
accommodate the bend leading into the water line
connection.
Floor
NOTE: The only GE Appliances approved
plastic tubing is supplied in the SmartConnect
plastic water supply line because the line is under
pressure at all times. Other types of plastic may
crack or rupture with age and cause water damage
to your home.
RISQUE DE DÉCHARGE
ÉLECTRIQUE
PELIGRO DE
DESCARGA ELÉCTRICA
plastic
Cold Water Line
49-1000364 Rev. 1