Leica DM5500 B Manuel D'utilisation page 61

Note:
If initializing failed ("InitError" on the Leica
SmartTouch), please see chapter "Trouble
Shooting", → p. 84.
During initialization, the stage will move to a
pre-set position. The stage is lowered. The mo-
torized tube will be set to the 100% VIS position.
All most recently used settings will be recalled.
!
Caution:
The focus position (DM5500 B and DM6000 B
only) and the lower threshold will also be
stored when switching off the microscope.
Fig. 64 LeicaScreen, menu page 'Status'
After the initialization is completed, the status
menu of the Leica SmartTouch (Fig. 64) shows
the current microscope setting.
Note: (Reset-Function)
The microscope can be reset to the default set-
tings:
• When the microscope is switched off,
press all 3 variable function keys (65.1) on
the left stand section.
• Switch on the stand.
• Hold the keys pressed down until initiali-
zation is completed.
• The standard information is shown in the
Leica SmartTouch.
• Switch off the instrument and switch it on
again. The settings are stored now.
Fig. 65 Left side of microscope
1 Variable function keys
1
8. Operation
61