Leica DM5500 B Manuel D'utilisation page 25

107/2 Lamp Housing
This lamp housing is used with a 12V 100W halo-
gen lamp, which is already mounted.
In case the lamp has to be removed:
• Remove the fastener screw on the housing
(Fig. 15).
• Remove the housing by pulling it upwards.
• Remove the lamp.
• Insert the new 12V 100W lamp (16.1) with the
dust cover straight into the socket until it
stops. Be sure that the lamp is inserted
straight.
• Remove the lamp's dust cover.
Caution!
Do not remove the lamp's dust cover until
you have installed the lamp. Avoid finger-
prints on the lamp.
• Replace the housing and fasten it in place us-
ing the fastening screw.
• Place the lamp housing in the transmitted light
lamp housing receptacle (17.2) and fasten it
with the clamping screw on the side.
• Connect the lamp housing to the power supply
for transmitted light (symbol:
• Now connect the lamp power cable of the mi-
croscope (17.5) to the Leica CTR5500 or
CTR6000 Electronics Box (18.1).
Fig. 17 Rear side of stand
1 Incident light lamp housing receptacle
2 Transmitted light lamp housing receptacle
3 12 V 100 W connection for transmitted light (symbol:
4 12 V 100 W connection for incident light (symbol:
5 Lamp power cable
Fig. 18 Rear side of Leica CTR6000
1 Connection for lamp power cable from the stand
) (17.3).
1
2
1
6. Assembly
)
)
5
3 4
25