In The Case Of Concentration Measurement; Change The Assignment Of The Temperature Current Output Signal (Zero Point Suppression And Measuring Range Spread); Change Device Number - Ecolab LMIT 08 Notice Technique

8.4.3.5.2 In the case of concentration measurement

Fig. 8.25
8.4.3.6 Change the assignment of the temperature current output signal
(zero point suppression and measuring range spread)
Fig. 8.26
NOTE
The NOTE in chapter
Fig. 8.27

8.4.3.7 Change device number

Fig. 8.28
Setting limits:
417101109_LMIT08.doc
The configuration currently set is displayed without CURSOR mark
and
8.4.3.5 also applies here.
To every LMIT 08
number.
1...999 or --- if no device number should be assigned.
- 70 -
Setting limits:
- zero_point:
0...80 % of the measuring range
- SPAN:
20...100 % of the measuring range
Setting limits:
- zero point:
0...50 °C
- SPAN:
50...150 °C
you can assign an individual device
Rev. 3-01.10