Connection; Selecting The Display In Measuring Mode; Display Texts In The Measuring Plane; Conductivity Or Concentration And Temperature Display In Standard Mode - Ecolab LMIT 08 Notice Technique

8.

Connection

Fig. 8.1
All the displays shown in the pictures below are purely examples.
NOTE
The values actually displayed depend on the nature of the measurement.
A printout of the factory-set configuration data is enclosed with the delivery.
8.1

Selecting the display in measuring mode

Selection of the display depends on the configuration of the equipment.
•
Conductivity display, if a conductivity measuring range is set.
•
Concentration display, if a product measuring range is set.
•
Display of the low power - conductivity
•
TCα display only if a conductivity display is set.
•
Display of current output signal
NOTE
For control structure see folding-out page at the end of the manual.
8.2

Display texts in the measuring plane

8.2.1

Conductivity or concentration and temperature display in standard mode

Fig. 8.2
Higher or lower deviation of the programmed current output interval (0(4)...20 mA) is shown left
hand of the measured value with a ↑ or a ↓ symbol.
8.2.2

Conductivity or concentration and temperature display in CIP version

Fig. 8.3
In the CIP version the active CIP range (range <1> to <4>) is displayed at the top on the left.
417101109_LMIT08.doc
Pos. Description
1 LC display
2 Contrast adjustment
3 Programme storage
4 Übergabestecker für CIP- bzw. PROFIBUS-Modul
Operating buttons
Pos. Symbol
5.1 NEXT
5.2
5
5.3
5.4 SEL/
- 64 -
Function
Selection of control levels
Increase the displayed value
Selection of a sub-menu
Decrease the displayed value
Selection of a sub-menu
Acknowledgement of an input
Store the displayed value
Rev. 3-01.10