Terminal Assignment Plan, Basic Pcb; Terminal Assignment Plan, Cip Module; Terminal Assignment Plan, Profibus Module Dpv1 And Pa - Ecolab LMIT 08 Notice Technique

7.2.4

Terminal assignment plan, BASIC pcb

Fig. 7.12
7.2.5

Terminal assignment plan, CIP module

Fig. 7.13
7.2.6

Terminal assignment plan, PROFIBUS module DPV1 and PA

Fig. 7.14
ATTENTION
With the switch S1 a bus termination of 120 Ω can be switched on.
This is necessary if the
417101109_LMIT08.doc
The shielding of the bus-connection wire inside the
bus-connetion wire inside the
exhausted separately.
LMIT 08 is the last unit in the RS485 loop.
1
LMIT 08
LMIT 08 is lead further on, the shielding has to be
- 63 -
Pos. Description
1 PE connection
2
Auxiliary power
3 F1 T0,4 A
4 0/4...20mA conductivity
5 0/4...20mA temperature
6 transmitter coil
7 PT 100
8 Receiver coil
9 Potential equalization
10 external
11 internal
Pos. Description
1 CIP control signals
2 Potential equalization
The connection options for
the CIP module are
described in chapter 14.3.
Pos. Description
1 PROFIBUS connection
The PROFIBUS connection
for the LMIT 08 is branched
by a T-piece on the
PROFIBUS line.
The max. cable length of
the individual line is 1 m.
has to be isolated. If the
Rev. 3-01.10