2.
Safety instructions
The conductivity and temperature transmitter
supply. Repairs must always be carried out on units when they are switched off and
unpressurized.
This transducer has been built and tested EN 61010-1, Part 1 and left the works in a safe and
fully operational state.
In order to maintain this state and ensure safe operation, the user must take note of the
instructions and warnings contained in these operating instructions.
If it is established that safe operation is not possible, the unit should be disconnected and
secured against accidental operation.
This happens when:
•
the unit shows visible damage
•
the unit no longer seems capable of operating
and
•
the unit has been stored for long periods in poor conditions.
Maintenance work with the power supply switched on must always be carried out by an
CAUTION
expert.
2.1
Pointers
In this manual, the pointers have the following meanings:
is used if imprecise or non-adherence to operating instructions, work instructions,
CAUTION
prescribed work procedures and the like can lead to injury or accident.
ATTENTION
IMPORTANT
NOTE
This heading is used if a special feature is being pointed out.
2.2
Numberings
Numberings marked with this sign ( ) describe an activity which must only be performed
by the installer / user.
417101109_LMIT08.doc
is used if imprecise or non-adherence to operating instructions, work instructions,
prescribed work procedures and the like can lead to the device being damaged.
is used when particular attention is required in operating the equipment.
LMIT 08
may only run on a 24 V, DC or AC
- 51 -
Rev. 3-01.10