Ferm MSM1040 Traduction De La Notice Originale page 9

Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
62841-1; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-5.
1. Lock-off button
2. Handle
3. On/off switch
4. Protective guard
5. Retracting protective guard
6. Saw blade
7. Adjustable fence
8. Knob for table extension
9. Fence
10. Table extension
11. Table
12. Mounting holes
13. Kerf plate
14. Knob for mitre adjustment
15. Lever for mitre adjustment
16. Scale for mitre angle
17. Indicator for mitre angle
18. Laser
19. Indicator for bevel angle
20. Scale for bevel angle
21. Workpiece clamp
22. Knob for bevel adjustment
23. Roller
24. Depth adjustment bolt
25. Slide rails
26. Dust bag
27. Carrying handle
28. Dust outlet
29. Locking bolt for slide rails
31. Stop bolt for 45° bevel angle
32. Stop bolt for 0° bevel angle
33. Screw retraction arm
34. Locking bolt for table extension
35. Locking bolt for adjustable fence
36. Adjustment bolt for fence
37. Front tilt protector
38. Position lock knob
39. Grub screw
40. Screw
41. Clamping flange
42. Clamping bolt
43. Spindle lock
44. Knob for workpiece clamp
45. Plate for depth adjustment
46. Laser switch
48. Screws for laser adjustment
50. Lock nut for 0° bevel angle
51. Fence bolts
3. ASSEMBLY
Before carrying out any work on the
machine, disconnect the mains plug
from the power supply.
Transport position
Fig. B
The position lock knob (38) makes it easier to
move the power tool when transporting it to
various working locations.
Unlocking the transport position (work position)
1. Press the handle (2) downwards slightly;
2. Pull the position lock knob (38) fully outwards
and lock it in place by turning it;
3. Slowly move the handle (2) upwards.
Locking the transport position (transport
position)
Before locking in transport position, make sure
that the depth adjustment bolt (24) is adjusted
to unlimited depth. This way, the handle (2) can
be moved fully downwards without touching the
depth stop. Also, remove all accessories that
cannot be securely fitted to the machine.
1. Loosen the locking bolt for slide rails (29) if
tightened;
2. Pull the handle (2) forwards towards yourself
9