What To Do If - ZANKER KOB25602 Notice D'utilisation

2
1
7
Carefully lift (step 1)
and remove (step 2) the
glass panel.
Clean the glass panel with water and soap. Dry the
glass panel carefully.
Installing the door and the glass panel
When the cleaning is completed, install the glass panel
and the oven door. Do the above steps in the opposite
sequence.

What to do if...

Warning! Refer to "Safety information" chapter.
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not operate.
The display shows 12.00.
Steam and condensation settle on
the food and in the oven.
If you cannot find a solution to the problem yourself,
contact your dealer or the service centre.
We recommend that you write the data here:
Model (MOD.)
14
The screen-printing zone must face the inner side of
the door. Make sure that after the installation the sur-
face of the glass panel frame on the screen-printing
zones is not rough when you touch it.
Make sure that you install the internal glass panel in the
seats correctly. Refer to the illustration.
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not set.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
There was a power cut.
You left the dish in the oven for too
long.
The necessary data for the service centre is on the rat-
ing plate. The rating plate is on the front frame of the
appliance cavity.
Remedy
Activate the appliance.
Set the clock.
Make sure that the settings are cor-
rect.
Do a check of the fuse. If the fuse is
released more than one time, con-
tact a qualified electrician.
Replace the oven lamp.
Set the clock.
Do not keep the dishes in the oven
for longer than 15 - 20 minutes after
the cooking ends.
.........................................