What To Do If - ZANKER KOB20601XB Notice D'utilisation

1
Open the door fully
and hold the two door
hinges.
3
Close the oven door
to the first opening posi-
tion (halfway). Then pull
forward and remove the
door from its seat.
5
Release the locking
system to remove the in-
ternal panel of glass.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The appliance does not heat up.
28
2
Lift and turn the lev-
ers on the two hinges.
4
Put the door on a
soft cloth on a stable
surface.
90°
6
Turn the two fasten-
ers by 90° and remove
them from their seats.
Possible cause
The appliance is deactivated.
2
1
7
Carefully lift (step 1)
and remove (step 2) the
panel of glass.
Clean the glass panel with water and soap. Dry the
glass panel carefully.
Installing the door and the glass panel
When you install the panel with a decorative frame,
make sure that the screen-printing zone looks to the
inner side of the door. Make sure that after the instal-
lation the surface of the glass panel frame on the
screen-printing zones is not rough when you touch it.
Make sure that you install the internal panel of glass in
the seats correctly (refer to the illustration).
Activate the appliance. Refer to
"Daily use".
Remedy