What To Do If - ZANKER KOU20601 Notice D'utilisation

5
Release the locking
system to remove the in-
ternal panel of glass.
2
1
7
Carefully lift (step 1)
and remove (step 2) the
panel of glass.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The cooking zones do not operate.
The appliance does not heat up.
The appliance does not heat up.
The oven lamp does not operate.
Steam and condensation settle on
the food and in the appliance.
If you cannot find a solution to the problem yourself,
contact your dealer or the service centre.
90°
6
Turn the two fasten-
ers by 90° and remove
them from their seats.
Possible cause
The appliance is deactivated.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
You left the dish in the appliance for
too long.
Clean the glass panel with water and soap. Dry the
glass panel carefully.
Installing the door and the glass panel
When you install the panel with a decorative frame,
make sure that the screen-printing zone looks to the in-
ner side of the door. Make sure that after the installa-
tion the surface of the glass panel frame on the screen-
printing zones is not rough when you touch it.
Make sure that you install the internal panel of glass in
the seats correctly (refer to the illustration).
Refer to the user manual for the hob.
Activate the appliance. Refer to
"Daily use".
Do a check of the fuse. If the fuse is
released more than one time, con-
tact a qualified electrician.
Replace the oven lamp.
Do not let the dishes stay in the ap-
pliance for more than 15-20 mi-
nutes after the cooking ends.
The necessary data for the service centre is on the rat-
ing plate. The rating plate is on the front frame of the
appliance cavity.
Remedy
27