Warranty / Service - Beurer BC 50 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
Power supply
2 x 1.5V
Battery life
For approx. 300 measurements, de-
pending on levels of blood pressure
and pump pressure
Classification
Internal supply, IPX0, no AP or APG,
continuous operation, application part
type BF
The serial number is located on the device or in the battery
compartment.
Technical information is subject to change without notification
to allow for updates.
• This device is in line with European Standard EN 60601-1-2
(in accordance with CISPR 11, IEC 61000-4-2, IEC 61000-
4-3, IEC 61000-4-8) and is subject to particular precautions
with regard to electromagnetic compatibility (EMC). Please
note that portable and mobile HF communication systems
may interfere with this unit.
• This device corresponds to the EU Medical Devices Direc-
tive 93/42/EEC, the German Medical Devices Act (Mediz-
inproduktgesetz) and the standards EN 1060-1 (non-inva-
sive sphygmomanometers, Part 1: General requirements),
EN  1060-3 (non-invasive sphygmomanometers, Part3:
Supplementary requirements for electro-mechanical blood
pressure measuring systems) and IEC 80601-2-30 (Medical
electrical equipment – Part 2-30: Particular requirements for
the basic safety and essential performance of automated
non-invasive sphygmomanometers).
• The accuracy of this blood pressure monitor has been care-
fully checked and developed with regard to a long useful life.
AAA batteries
26
• If using the device for commercial medical purposes, it must
be regularly tested for accuracy by appropriate means. Pre-
cise instructions for checking accuracy may be requested
from the service address.

11. Warranty / service

In case of a claim under the warranty please contact your local
dealer or the local representation which is mentioned in the list
"service international".
In case of returning the unit please add a copy of your receipt
and a short report of the defect.
The following warranty terms shall apply:
1. The warranty period for BEURER products is either 5 years
or- if longer- the country specific warranty period from date
of Purchase.
In case of a warranty claim, the date of purchase has to be
proven by means of the sales receipt or invoice.
2. Repairs (complete unit or parts of the unit) do not extend the
warranty period.
3. The warranty shall not be valid for damages because of
a. improper treatment, e.g. nonobservance of the user in-
structions.
b. repairs or tampering by the customer or unauthorised third
parties.
c. transport from the manufacturer to the consumer or during
transport to the service centre.
d. The warranty shall not be valid for accessories which are
subject to normal wear and tear (cuff, batteries etc.).

Publicité

Table des Matières
loading

Table des Matières